Installing a Law Tactical folding stock adapter

Warning:

If you have any doubts in your ability to perform the following actions, stop immediately and seek assistance from a qualified gunsmith. If you need clarification on any of the steps below, please contact us to speak with a member of our support team.

Always wear proper personal protective equipment (PPE) including adequate eye protection when servicing a firearm.

Installing Law Tactical folding adapter

  1. Remove the weight from the rear of the bolt carrier. It is held in with a single roll pin. Knock out the roll pin and pull out the weight 
  2. Follow the instructions included with the Law Tactical adapter

Because you are removing weight from the carrier, you will need to make it up with the buffer. We recommend running an 8oz buffer or 10oz buffer. Please note, the heavier buffers are extended in length so you will not need to use a buffer spacer.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.